Lifted and Creased Tabs
Wind gets under a tab, folds it back and leaves a crease across the shingle. A creased tab has lost its strength along that line and usually snaps off in the next storm, so the right fix is replacing the shingle, not gluing it down. Tabs that lifted without creasing can often be hand-sealed with dabs of roofing cement.
Creased tabsHand sealingShingle swap
Nail Pops and Exposed Fasteners
Nails driven at an angle, set too high, or pushed out as the decking swells and shrinks will rise and lift the shingle above. The contractor pulls or resets the nail, drives a new one beside it into solid wood, and seals the old hole. Bare nail heads on caps and vent flanges get sealed or replaced.
Nail popsRidge nailsFastener sealing
Cracked Pipe Boots
Neoprene pipe boots tend to crack years before the surrounding shingles age out. Water runs down the pipe and drips into the attic or a bathroom ceiling. A roofer lifts the shingles above, removes the old boot, installs a new one sized to the pipe and reseals the courses. Lead and silicone boots cost a little more and last longer.
Neoprene bootLead bootPlumbing vents
Step Flashing and Counterflashing
Where a roof meets a sidewall, each course of shingles needs its own L-shaped piece of step flashing, tucked under the siding or covered by counterflashing on brick. Missing pieces, one long bent strip, or caulk standing in for metal are the usual culprits. Doing it right may mean pulling siding or grinding a reglet into a mortar joint.
Step flashingCounterflashingReglet cut
Ridge Cap and Hip Repair
Caps along the ridge and hips are bent over the peak and exposed on both sides, which makes them the first pieces to crack in hard cold. The fix is new caps from a matching line, nailed at the correct exposure with the last piece sealed. If a ridge vent sits under the caps, the contractor should check its baffles and end plugs too.
Ridge capHip shinglesRidge vent
Matching Older Shingles
Matching is frequently the trickiest part of a spot repair. Leftover bundles in the garage carry a label with the manufacturer, product line and color name. Without one, the roofer compares exposure, tab shape and granule blend against current lines. On a weathered roof the new pieces will look brighter for a while, and you should be told that before work begins.
Bundle labelsGranule blendProfile match